Control board dimensions and supply voltage

Control board supply voltage from 7 VAC to 15VAC, and maximum supply current is 1 A, and there are voltage protection in all Control board input and output terminals, its 20VAC maximum.

And control board dimension is 24cm*18cm.

 

 

Feature and Specifications

 

Phase sequence and phase correction works from 150 to 450 VAC) 380 or 220 Volt electricity) and arrows relay on board

Supports two ways elevator with separate out callings up to 4 floors. Please tell us before ordering

Saving the control panel terminations wiring and efforts by using terminal board extension unit

Saving terminal blocks during manufacturing the control panel. Will save 32 terminal blocks

The card supports 2 CAM & 2 full Automatic doors or half automatic door for any chosen programmed floors up to 12 floors

Errors and alerts appear on normal 7-segment 26 codes will be appeared

Card is 8 floors down collective with out and inner registration common Up to 14 floors on the same control card. Please tell us before ordering

Supports all indicator types (7 segments – binary code – gray code – serial – 1.2.3.4.5)

Overweight input directly on board

Full load input directly on board

All safeties are ready, (GAHEZ feature) and can be cancelled from programming

Elevator life timer to block the lift after a certain hours up to 9999 hour ( max 416 day)

Separated relay for up and down arrow

Separated relay for automatic door (one relay for open and other for door close)

Over voltage protection above to 20 VAC

 

Door fork safety

Lock door safety

Fire man feature

VIP feature

Delete a certain calling door from programming

Cabin stop switch can delete the requests during stopping at the floor

The upper and down limit switch reverse direction protection

Push button calling

Up-down collective selective calling

Self-test mode

Supports all operation modes (duplex – triplex – hydraulic)

 

The card supports all these collection modes

Down collective mode

Up – Down collective mode

Up – Down collective selective mode

Push button mode

Duplex with all previous modes

Triplex with all previous modes

Saving cabin card

Hydraulic with all previous modes

There are all protection timers to protect the machine and the elevator mechanical parts during movement

All hydraulic elevator features (3 valves – 4 valves – star/delta) and the feature of the cabin relevel position

All malfunctions and timers lead to stopping the cabin at the nearest floor

There is a normal programming and advanced programming to adjust and activate all features

Automatic door opening feature when slipping from the floor level magnet

Cancellation of all orders during stopping at the floor

Solve the problems of the self-registration of the order button in any floor

Signal point to check the mechanical brake to monitor the movement of the brake during opening and start operation

There is a timer for displaying faults on the indicator to facilitate the diagnosis of faults

All inputs and outputs of the control board have been protected from sudden high and low voltage

The same programming as the old “KAS” control board, in addition to advanced programming with all the new features

The same size connections and arrangement of the terminals of the old “KAS” control board.

Supports two way elevator with separated out requests up to 4 floors. With any different door kinds Please tell us before ordering

It can be connected with a rosette assembly card to save the time of manufacturing the control panel (it saves 34 rosettes in the control panel) and the connection is made through 4 cables inside the package )

It’s recommended for 2 speed control panel and for variable speed panel, please use card “KAS inverter ”.