Control board dimensions and supply voltage

Control board supply voltage from 7 VAC to 15VAC,
and maximum supply current is 1 A
and there are voltage protection in all Control board input and output terminals, its 20VAC maximum

And control board dimension is 27*30 cm and can be connected in vertical or horizontal position

Feature and Specifications

• A control board dedicated to working in the inverter panels contains UPS and compatible with all types of inverters which contains only an  emergency input signal and UP
• It saves 7 control relays (fast – slow – down – up – lighting ,maintenance and emergency relay)
• It saves CAM contactor and CAM Bridge and 1- volt Bridge
• There are 5 switches on the control board to operate the inverter manually and also can operate the CAM manually by using SW on the control board to check the connections
• Arrows and gungs are taken directly from the control board
• There is a relay for MS (medium speed) on the control board, and it can be activated from programming
• control board supports all signals for : Mains contactor – UPS contactor – Emergency signal and maintenance for inverter
• board contains 3 phase to detect phase absence
• motor temperature sensor control found on the board
• The card supports 2 CAM & 2 full Automatic doors or half automatic door for any chosen programmed floors up to 14 floors
• Errors and alerts appear on normal 7-segment 26 codes will be appeared
• Card is 16 floors down collective with out and inner registration common
• Supports all indicator types (7 segments -binary code – gray code – serial -1.2.3.4.5)
• Overweight input directly on board
• Full load input directly on board
• All safeties are ready, (GAHEZ feature) and can be cancelled from programming
• Elevator life timer to block the lift after a certain hours up to 9999 hour (max 416 day)
• Separated relay for up and down arrow
• Separated relay for automatic door (one relay for open and other for door close)
• Over voltage protection above to 20 VAC
• Door fork safety
• LOCK door safety
• Fire man feature
• VIP feature
• Delete a certain calling door from programming
• Cabin stop switch can delete the requests during stopping at the floor
• The upper and down limit switch reverse direction protection
• Push button calling
• Up-down collective selective calling
• Self-test mode
• Supports all operation modes (duplex – triplex – Cabin)
• The card supports all these collection modes :

Down collective mode
Up – Down collective mode
Up – Down collective selective mod.
Push button mode
Duplex with all previous modes
Triplex with all previous modes
Saving cabin car

• There are all protection timers to protect the machine and the elevator mechanical parts during movement
• All malfunctions and timers lead to stopping the cabin at the nearest floor
• There is a normal programming and advanced programming to adjust and activate all features
• Automatic door opening feature when slipping from the floor level magnet
• Cancellation of all orders during stopping at the floor
• Solve the problems of the self-registration of the order button in any floor
• Signal point to check the mechanical brake to monitor the movement of the brake during opening and start operation
• There is a timer for displaying faults on the indicator to facilitate the diagnosis of faults
• All inputs and outputs of the control board have been protected from sudden high and low voltage
• The same programming as the old KAS control board, in addition to advanced programming with all the new features
• The same size, connections and arrangement of the terminals of the old KAS control board