Control board dimensions and supply voltage
Control board supply voltage from 7 VAC to 15VAC, and maximum supply current is 1 A, and there are voltage protection in all Control board input and output terminals, its 20VAC maximum.
And control board dimension is 24cm*18cm.

Feature and Specifications

• Phase sequence and phase correction works from 150 to 450 VAC) 380 or 220 Volt electricity) and arrows directed connected on the control board
• Supports two ways elevator with separate out callings up to 4 floors, Please tell us before ordering
• Gungs and Up & down arrows connected directly from the control board without any additional wiring
• Control board contains a 7-segment display to display door number and elevator errors
• The card supports 2 CAM & 2 full Automatic doors or half automatic door for any chosen programmed floors up to 12 floors
• Errors and alerts appear on normal 7-segment 26 codes will be appeared
• Card is 8 floors down collective with out and inner registration common
• Supports all indicator types (7 segments – binary code – gray code – serial – 1.2.3.4.5)
• Overweight input directly on board
• Full load input directly on board
• All safeties are ready, (GAHEZ feature) and can be cancelled from programming
• Elevator life timer to block the lift after a certain hours up to 9999 hour ( max 416 day)
• Control board contains 12 VDC bridge
• Separated relay for automatic door (one relay for open and other for door close)
• Over voltage protection above to 20 VAC
• Door fork safety
• LOCK door safety
• Fire man feature
• VIP feature
• Delete a certain calling door from programming
• Cabin stop switch can delete the requests during stopping at the floor
• The upper and down limit switch reverse direction protection
• Push button calling
• Up-down collective selective calling
• Self-test mode
• Supports all operation modes (duplex – triplex – hydraulic)
• The card supports all these collection modes :
  Down collective mode
  Up – Down collective mode
  Up – Down collective selective mode
  Push button mode
  Duplex with all previous modes
  Triplex with all previous modes
  Saving cabin card
  Hydraulic with all previous modes
• There are all protection timers to protect the machine and the elevator mechanical parts during movement
• All hydraulic elevator features (3 valves – 4 valves – star/delta) and the feature of the cabin relevel position
• All malfunctions and timers lead to stopping the cabin at the nearest floor
• There is a normal programming and advanced programming to adjust and activate all features
• Automatic door opening feature when slipping from the floor level magnet
• Cancellation of all orders during stopping at the floor
• Solve the problems of the self-registration of the order button in any floor
• Signal point to check the mechanical brake to monitor the movement of the brake during opening and start operation
• There is a timer for displaying faults on the indicator to facilitate the diagnosis of faults
• All inputs and outputs of the control board have been protected from sudden high and low voltage
• The same programming as the old KAS control board, in addition to advanced programming with all the new features
• Supports two way elevator with separated out requests up to 6 floors. With any different door kinds Please tell us before ordering
• It’s recommended for 2 speed control panel and for variable speed panel, please use card KAS inverter